I denna rapport predikteras livslängden, med avseende på utmattning, för en hjullastarskopa. Två av de mest kritiska svetsarna utvärderas enligt IIW:s (International Institute of Welding) rekommendationer genom nominella spänningsmetoden, hot spot-metoden och Effective notch-metoden. Beräkningarna utförs med hjälp av finita elementmetoden. Genom att utföra töjningsmätningar på hjullastarskopan i drift erhålls spänningsdiagram. Dessa uppmätta spänningsdiagram analyseras med rain-flow count-metoden.

Eco Log AB i Söderhamn är en tillverkare av skogsmaskiner. De tillverkar både skotare och skördare. På deras skördare sitter fyra pendelarmar som ersätter hjulupphängningen på fordonet. Dessa motverkar att fordonet lutar vid körning i sluttningar. Varje pendelarm drivs av en hydraulkolv som justerar nivelleringen.Då inga beräkningar med avseende på utmattning och livslängd genomförts sedan en omkonstruktion av pendelarmarna är det nödvändigt att analysera och utvärdera pendelarmarna.

In most software engineering project, users are only involved in the beginning of the project as a help to design the requirements specification but users can be involved after this phase too, but is it effective to do so? With this report we would like to investigate how effective it is to involve users after the requirements specification has been written and approved. To find out how effective it is to involve the users we try some fast and simple involvement techniques on a quite far gone project. These techniques include ethnographic studies, prototypes and surveys. We also interviewed a couple of people who work with usability and finally delivered a report with our results to them to find out if they found our result relevant.

Non-contact anterior cruciate ligament (ACL) injuries is a serius and traumatic injury to the knee that is common in female soccer players and often force the player to quit or lower the level of activity because of lost stability in the knee or from fear to suffer  a new injury. Female soccerplayers have a higher risk than their male counterparts to get an ACL rupture and especially adolescent females have a high risk. The most common causes to a non-contact ACL rupture is side-cutting manuvers and landing after jumping. Every other player with an ACL rupture develops osteoarthritis within 10-15 years from the time of injuryResults: The higher risk for females to incur a ACL rupture is due to smaller intercondylar notch, they?re in the follicular or ovulatory phase of their menstrual cycle, increased knee laxity, dominance in the quadriceps muscles, flexion in hip and valgus movement in the knee.

In most software engineering project, users are only involved in the beginning of the project as a help to design the requirements specification but users can be involved after this phase too, but is it effective to do so? With this report we would like to investigate how effective it is to involve users after the requirements specification has been written and approved. To find out how effective it is to involve the users we try some fast and simple involvement techniques on a quite far gone project. These techniques include ethnographic studies, prototypes and surveys. We also interviewed a couple of people who work with usability and finally delivered a report with our results to them to find out if they found our result relevant. By also documenting how much time we spent involving users we will show to which degree user involvement is effective. We found out that a couple of fast techniques could get very much result in the form of usability enhancing suggestions to the developers.

The purpose of this thesis is through a case study and a survey; to examine the most appropriate communication channels between a sender and a receiver. It also aims to make this relationship more effective.The following questions are to be answered:1. Which communication channels ought to be used to optimize the message from Skara Näringslivsoffensiv to its target group?2. Which communication channels is Skara Näringslivsoffensiv planning to use?3.

It is of increasing importance to in the most effective possible way, manage and control all the transactions of raw materials, products and information that are exchanged between an organization and all its operators. These flows and the need for strategy and managing the processes of planning, implementing and control of the supply chain, has given name to the concept supply chain management. Supply chain management involves all movement and storage of raw material, and all the processes that is needed to manufacture a product from origin to consumption. Globalization, technology and increasing time and quality-based competition are all driving forces behind the concept and reasons for an increasing interest in supply chain management.The purpose of this essay is to by using a qualitative case study examine which decisive success factors that can be identified for effective supply chain management. We have compiled different theories on the subject to use for analyzing a case study Li & Fung, who is a successful supply chain management company.

This thesis lays the foundation of the future routines of effective error repotring fortraffic devices in the raiway sector.If a device, for example a timetable display, stops working it is vital that the device isfixed as fast as possible so that the travelers dont miss any important information.The methods that are used today are old and not very effective. It can take time forthe repairmen to find the right device or locating the broken component. At the sametime he is supposed to maintain telephone contact with central control throughoutthe whole session.The need for a new, more effective, system is vital to make the whole repair pfocessmore effective and let the repairmen work without having to contact the centralcontrol by phone.I started this work by examining the possibilities of assigning every object with aunique identifier (ID tag) that could be accessed by a manual scan device. The ideawas that the ID tag could holw information about the object and be obtained byscanning the ID and get the information presented on a mobile device.The work also included building a internet application that enabled the reader to seeand change the information on the ID tag.The result was a database that stored information of different objects which could beobtained by scanning the ID tag and presented by a internet application..

In this work, a method was developed and evaluated for calculating the life of welds under the influence of fatigue loads from a vibration environment. Typically, a shaker table is used for testing a component against vibration loads. The shaker table creates a vibration environment that is defined in the frequency domain by a power spectrum.Similarly, a virtual vibration table can be used to calculate the same type of load environment, which can then be used to calculate the expected lifetime. The benefit of this method is that it can be used in design, as well as in simulation of tests before physical verification tests are carried out.Today there are methods for calculating fatigue life of non-welded base material, but since many components contain welded joints, there is a need to apply this method to those types as well. To achieve this, the thesis combines two different areas, which together provide a method for fatigue assessment of welds using a virtual shaker table.The methodology is carried out by modeling the component, and its welded joints, in a finite element program.

Creating a database to manage medical data is not the easiest. We create a database to be used for a presentation tool that presents medical data about patients that is stored in the database. We examine which of the three databases, MySQL with relational design, MySQL with EAV design and MongoDB that are best suited for storing medical data. The analysis i performed in two steps. The first step handles the database that is most effective to retriev data. The second step examines how easy it is to change the structure of the various databases. The results show that depending on whether efficiency or maintenance is most important, different databases are the best choise. MySQL with relational design proves to be most effective while MongoDB is the easiest to maintain..

The object of this study is to examine the effective functionality of an OPAC-system while a few participants interacted with the catalogue. I?ve used Carl Martin Allwood?s (1998) four designed usability factors to be able to estimate the effective functionality of the online catalogue. Theoretic basis is Human Computer Interaction together with Allwood?s four defined usability factors.

Background: Budgets has always been a main factor for the management of organisations. Yet, lately has the role of budgets been increasingly questioned. But how is an organisation managed without budgets and what other alternatives can be used? And can these instruments work more effective?Purpose: The purpose of this essay is to describe how non-budget management distinguish compare to traditional management and how to design an effective non-budget system of management. Furthermore we intend to explain the reasons to such management and to present a model for how such a management can be performed.Research method: Empirical material has been performed based on seven interviews with persons within Svenska Handelsbanken.

The consumer of today is bombarded by an increasing number of commercial messages, which makes it harder and harder for brands to cut through the clutter. Because of this, new methods are developed and introduced to the market every day. One of the most widely discussed of these methods is guerrilla advertising. Even though the method has received numerous praises there are not any academic proofs supporting these arguments. The authors, of this thesis, have examined if guerrilla advertising is more or less effective compared to traditional advertising and what the reasons for the result are.

Regional European Offices with the purpose to represent regions and municipalities in the EU-system have had a substantial expansion over the last years. One example is the North Sweden European Office for the counties of Norrbotten and Västerbotten, consisting of seven different headmen who are representing both the private sector as well as the public system. This diverse leadership representation makes North Sweden a very good example on a so called Quango, organisations that stand under simultaneous influence from both public and private sectors. These Quangos opens up new possibilities to solve public problems, but they also bring together two different working models which is not always easy to handle for a Quango. According to earlier surveys some characteristic Quango problems within North Sweden exist, for example the ability to prioritize and thereby be as effective as possible.

Aim: The aim is to create a review that examines different forms of massage therapy and their effects on hypertension.Method: Literature review of 10 scientific articles on the subject of massage and its effects on blood pressure. The literature searches were made with PubMed and Cinahl using the keywords "massage therapy", "effects" and "blood pressure".Results: The articles showed that massage had a positive effect in lowering blood pressure. This could be explained by greater extent of relaxation in the participants investigated and an increased activity of parasympaticus and reduced secretion of stress hormones. The articles do not agree on what form of massage therapy is most effective in lowering blood pressure and it is uncertain for how long the effect can remain.Conclusion: Massage is usually seen as a treatment without scientific basis. There is evidence that suggests that massage therapy is an effective treatment for lowering blood pressure.